I did read a post here regarding the Omni-Rig. I'm not sure where to go next to try and trouble shoot this issue. Once I close down HRD, the FT-3000 will never go back into Transmit mode, and SDRuno continues to track the FT-3000 through all of this. This pattern repeats for as long as I leave the HRD application up and running. The communications has been lost error message will continue to come up on Ham Radio Deluxe and a few seconds after that message the FT-3000 will switch back into Transmit mode and stay in transmit mode until I bump the PTT switch again. Once the PTT switch is bumped the radio switches back to receive mode.
There is no audio to the radio so it's not actually transmitting anything out over the air but it will sit there in Transmit mode until I bump the PTT switch on the microphone. A few seconds later the FT-3000 will switch to Transmit Mode. (This is actually the connection between Ham Radio Deluxe and SDRuno, via the virtual COM ports, COM-10 to COM-11. Now I Launch Ham Radio Deluxe and it starts up and appears to be tracking SDRuno, but a few seconds later I get a message in Ham Radio Deluxe that the communications between Ham Radio Deluxe and the FT-3000 has been lost. Any change in SDRuno is reflected on the FT-3000 and any change on the FT-3000 is reflected in SDRuno, so that part appears to be working OK. (LO) I have SDRuno up and running and tracking the FT-3000. I set Omni-Rig in SDRuno ORIG to RIG1 with all boxes checked except Sync Center Freq. Omni-Rig is set for RIG1 COM-5, which is the Enhanced COM port for the FT-3000. I set the CAT control in SDRuno to COM-10 and connected. I launched Ham Radio Deluxe and set up a new Port, using Yaesu, FT-3000, COM-11, RTS-checked, Baud 38400. I installed the 64-bit Virtual Serial Port Emulator, ( VSPE) as shown in the SDRPlay YouTube video and set up a pair, COM-10 and COM-11 and initialized these. The issue comes up when I launch Ham Radio Deluxe. I have Omni-Rig installed with the FT-3000 picked and the RSP1A connects to the FT-3000 and they sync up and all works well. I am trying to get my FTdx-3000 to work with my SDRPlay RSP1A, and Ham Radio Deluxe.
0 kommentar(er)
